HOMAG KAL 210/7/A20/S2 Kanlistmaskin

Min. edge thickness 0.3 mm
Max. edge thickness 3 mm 
Max. forward feed speed 25 m/min
Pressure with rubber belt
Panel support guides 
with positioning by NC 
Infeed panel alignment system 
NO. PANEL SIZING / MILLING UNITS 
Unit : pre-milling unit
automatic timed intervention
motor power : 3 KW
r.p.m. : 9000 RPM
Lamps to preheat the side of the panel 
Edge coil magazine 
glue pot for EVA hot melt glue
premelter for EVA hot melt glue 
Roller set to press the edge
no. pressure roller 7
with positioning by NC 
No. Edge Processing Units 7
NO. EDGE PROCESSING UNITS 1
Processing Unit : end trimming
no. motors : 2
motor power : 0.8 KW
r.p.m. : 12000 RPM
NO. EDGE PROCESSING UNITS 2
Processing Unit : top and bottom rough trimming
no. motors : 2
motor power : 1.5 KW
r.p.m. : 12000 RPM 
NO. EDGE PROCESSING UNITS 3
Processing Unit : Corner rounding
Constructor model : FF12
no. motors : 4
motor power : 0.4 KW
r.p.m. : 12000 RPM
NO. EDGE PROCESSING UNITS 4
Processing Unit : milling hogging
no. motors : 1
automatic timed intervention 
motor power : 5 KW
r.p.m. : 11600 RPM
NO. EDGE PROCESSING UNITS 5
Processing Unit : edge scraping
Constructor model : PN10
NO. EDGE PROCESSING UNITS 6
Processing Unit : glue scraping
NO. EDGE PROCESSING UNITS 7
Processing Unit : buffing
no. motors : 2
Spray unit yes
Control system PC22 Visa översättning