Machine number: 706
Operating voltage: 400 V
Frequency: 50 Hz
Connection: 20 kW
Rated current: 39 A
Control unit: TRAUB SYSTEM TX 8H
Largest passage: 65 mm
Smallest passage: 15 mm
Thread on collet chuck: M85 x 1.5LI
Fitting diameter of collet chuck front bearing:
Outer diameter: 180 mm
Diameter inside: 120 mm
Rear bearing:
Outer diameter: 170 mm
Diameter inside: 110 mm
Collet chuck. max. 52/7.2 kN
Stroke collet feed: 100 mm
Feed force: 1600 N
Speed of the work spindle: 35 - 3150 rpm
Grooving slide X2 axis:
Number of slides: 4
Total slide stroke: max. 56 mm
Working stroke: max. 33 mm
Feed force: 4000 N
Rapid traverse speed: 15 m/min
Feed speed: max. 2.5 m/min
Ball screw drive: 25 x 5 mm diameter
Feed cylinder: 35 mm diameter
Carriage length: 320 mm
Carriage width: 112 mm
Guide width: 30 mm
Turret slide:
Longitudinal stroke Z-axis: 250 mm
Transverse stroke X-axis: 80 mm
Rapid traverse speed X- and Z-axis: 20 m/min
Ball screw drive X-axis: 25 x 5 mm
Z-axis: 32 x 10 mm
Number of tool holders: 8
The machine has the axes X1, Z1, C1, X2 and Z3
Incl. the tool holders located in the tool turret
Incl. chip conveyor and bar feeder from the manufacturer TRAUB Prikaz prevoda